Hot Air Welder for Tarps and Banners/Hot Air Welder

The automatic welding machine is designed to weld plastic materials. The automatic welding machine can weld advertising inkjet fabric, inkjet cloth, light box cloth, thick PVC cloth, mesh cloth, tarpaulin and other PVC, PE, plastic materials that can be hot melted. It is small, light and easy to operate.

Used imported Switzerland Leister heat gun. Its lifetime can reach 8-10 years. Its heat system is the most advanced in the world.

Its performance is very stable, and easy to maintain. Its temperature fluctuation is 1 degreee.

General instruction for safety:
Warning: The basic principal of safe protection should be followed to reduce the danger of fire in disaster, electric shock and personal harm. Please pay attention to the following items carefully before operation.

Keep the working place clean.
Messing up and the disorderly working place cause disaster
Choose the work place carefully and use the machine in a bright and dry circumstance.
The electricity, controlling box and protective facilities have to be in the proper order after finishing daily work. The electrical power supply has to be switched off definitely.
The machine has to be stopped before gets maintenance or replacing the parts.
Use standard or indicated tools when dismantling or replacing parts.
For safety and the long life of the machine, please do not let the machine operates overtime.
If any special incidents happened, please stop the machine first for repairing, And do not deal with the special incident with improper procedures.
If the machine is operated on land, keep the work place clean and no dust there. If dust or something blocks the inhaling filter of heater, the heating wind can not come cut adequately and then temperature inside of filter will rise to let the heater burn down.

Operation:
1. Make the cloth for seaming flat and put it underneath. Fix both ends by adhesive tape or something else.
2. The overlap width of the two pieces is about 3-mm, the width of the nozzle of hot seaming machine.
3. Put the machine nozzle between two overlap pieces. The press-wheel should be at left side of nozzle. The nozzle also need align with side of upper piece of cloth.
4. Switch on the motor power and then adjust speed.
5. Turn on the movement switch.
6. Press heating power key to adjust temperature.
7 Turn the bar by anticlockwise to fix the position to startup automatic movement. The machine will go along with the overlap path by itself.
8. Turn the bar by clockwise to cease the automatic work.
9. The operator should control the moving direction and make sure the nozzle connect both with upper and under piece of cloth.
Three reasons for purchasing Hot air welding machine:

This is the Inevitable trend of the development of Printing industry(Machine insteads of human is the important manifestation of development of the productivity and the inevitable trend. )

Reflect humanistic care to staff. Using 502 and other glue. It can dirty the hands and the cloth, and also the smell of the glue is bad for the healthy of the staff.

Improve work efficiency, saving the cost of glue. It just consumes 1.3 degrees per hour. But it can weld 5-8 meters per minute. Requires one person operate and finish welding.

Notice:
1. During operating, if the surface cloth is dissolved and scorched or the cloth are not sticked together, please stop to adjust the temperature or speed.
2. During operating, if the seaming part is not in right position, please stop to adjust fixing position.
3. During operating, make sure clothes are flat so that stick together smoothly.
4. The hot wind of heater cannot touch the press-wheel or the rubber of press-wheel is easy to be burned down.
5. Adjust temperature to zero before turn off the heater. Switch off after 5-10 minutes.